Custom overall wardrobe measurement rules

  • Detail

The key step of the overall wardrobe is measurement, and the measuring ruler must be careful and meticulous, so as to create a perfect wardrobe. There are many measurement rules for the measurement of the overall wardrobe. Let's take a look at the measurement rules of the cabinet

1. Strictly follow “ Three heights and three widths are measured, that is, three heights are taken from the left, middle and right, and three widths are taken from the top, middle and bottom respectively, so as to find the perpendicularity and error of the on-site wall, and avoid the wrong size filling

2. If there are multiple sets of cabinets in a room, or there are special shapes on site, and the user has special requirements, the designer reminds that the length, width and height of the room should be drawn. The special requirements of the user should be clearly recorded, and the entire layout should be drawn in the drawing, clearly indicating the size of the main channel and the attached channel

3. Reservation of installation position:

(1) embedded wardrobe: generally, 50mm is reserved for width and height respectively to facilitate the installation of connectors

(2) ultra high cabinet: if the height of the cabinet exceeds 2430mm, it needs to be made into a cabinet with upper and lower butt joints. At this time, the height deduction size is not less than 20mm

(3) open wardrobe: when there is no obstacle on the left and right of the cabinet, the width will not need to be deducted, and the height is reserved for 50mm

(4) push in cabinet: the cabinet is pushed into the installation position after it is installed outside. The upper, middle and lower width, inner and outer width, upper, middle and lower height, and inner and outer height should be measured respectively. Similarly, the smallest dimension is taken as the measurement dimension, and the width and height can be deducted by 20mm from the installation position, so as to ensure the successful installation of the cabinet at one time

(5) precautions for embedded cabinet design: since there will still be flash joints after the cabinet is sealed with the sealing plate, which will affect the appearance, in principle, when designing a fully embedded cabinet, it is designed as an external sliding door (except for the ceiling line or gypsum line on site)

4. Sketch drawing: this link requires the designer of the wardrobe brand to communicate with the customer on site. Both parties should draw a sketch together, and the basic requirements of the user should be clearly written in the drawing (for example, the user needs several drawers, and other hardware, etc.). Once both parties jointly finalize the drawing style, it can avoid the great contrast between the company's drawing and the customer's requirements, resulting in repeated communication, repeated modification, and delayed production progress, Reduce work efficiency

5. If there are other requirements for on-site installation: if the plate is to be sealed, special shape, uneven ground, on-site treatment, and on-site hole excavation are required, they should be carefully recorded in the measurement sheet to ensure the success of door-to-door installation at one time

6. The cabinet should be measured in three heights: left, middle and right. If there is a ceiling, the internal and external height of the installation position of the cabinet should be measured. Generally, there is a height difference in the artificial ceiling, because the measurement data should take the shortest size as the measurement data, and this situation should be declared to the user on site

7. When the skirting line has been installed on site, it will prompt the user that the cabinet cannot be completely flush with the wall, but it will not affect the installation effect and use; If the skirting line is not installed, the user will be prompted to decide whether to install it according to the site conditions. If the user must require the wardrobe body to be against the wall, the side plate of the visible surface can be extended back by 20mm in the design, and the corner can be cut on site or in the factory. In this way, the cabinet body looks completely against the wall from the side




Copyright © 2011 JIN SHI